Currently test/run uses wildcards to run all of the tests in a directory.
However, that wildcard list is filtered down by the "onlyfor" directives
in the test files... usually to a single file.
Therefore, just explicitly list the files we *really* want to run for this
test mode. This makes it easier to see at the top level what tests will
be executed, and to change that list temporarily while debugging specific
failures.
This means the "onlyfor" directive no longer has any purpose, and we can
remove it. "onlyfor" was also the only used of the $MODE variable, so we
can remove that too.
Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
ip(8)'s ability to take abbreviated arguments (e.g. "li sh" instead of
"link show") is very handy when using it interactively, but it doesn't make
for very readable scripts and examples when shown that way.
Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
There are a few occurrences of this assignment, which are needed to
re-add ::1 as loopback address after the MTU has been increased
back from a value below 1280 bytes.
This one, however, is redundant, and causes an error in the
execution.
Signed-off-by: Stefano Brivio <sbrivio@redhat.com>
With recent improvements, we're not CPU-bound at all while testing
UDP performance. Give the VM more memory and CPUs, forward two
additional ports, start up to four threads in parallel, and give
single iperf3 threads higher bandwidth targets.
Signed-off-by: Stefano Brivio <sbrivio@redhat.com>
On most recent CPUs, that's a better indication of all-core turbo
frequency, or non-turbo frequency, than /proc/cpuinfo.
Signed-off-by: Stefano Brivio <sbrivio@redhat.com>
