passt/port_fwd.h
David Gibson d5b80ccc72 Fix widespread off-by-one error dealing with port numbers
Port numbers (for both TCP and UDP) are 16-bit, and so fit exactly into a
'short'.  USHRT_MAX is therefore the maximum port number and this is widely
used in the code.  Unfortunately, a lot of those places don't actually
want the maximum port number (USHRT_MAX == 65535), they want the total
number of ports (65536).  This leads to a number of potentially nasty
consequences:

 * We have buffer overruns on the port_fwd::delta array if we try to use
   port 65535
 * We have similar potential overruns for the tcp_sock_* arrays
 * Interestingly udp_act had the correct size, but we can calculate it in
   a more direct manner
 * We have a logical overrun of the ports bitmap as well, although it will
   just use an unused bit in the last byte so isnt harmful
 * Many loops don't consider port 65535 (which does mitigate some but not
   all of the buffer overruns above)
 * In udp_invert_portmap() we incorrectly compute the reverse port
   translation for return packets

Correct all these by using a new NUM_PORTS defined explicitly for this
purpose.

Signed-off-by: David Gibson <david@gibson.dropbear.id.au>
2022-09-24 14:48:35 +02:00

34 lines
817 B
C

/* SPDX-License-Identifier: AGPL-3.0-or-later
* Copyright Red Hat
* Author: Stefano Brivio <sbrivio@redhat.com>
* Author: David Gibson <david@gibson.dropbear.id.au>
*/
#ifndef PORT_FWD_H
#define PORT_FWD_H
/* Number of ports for both TCP and UDP */
#define NUM_PORTS (1U << 16)
enum port_fwd_mode {
FWD_SPEC = 1,
FWD_NONE,
FWD_AUTO,
FWD_ALL,
};
#define PORT_BITMAP_SIZE DIV_ROUND_UP(NUM_PORTS, 8)
/**
* port_fwd - Describes port forwarding for one protocol and direction
* @mode: Overall forwarding mode (all, none, auto, specific ports)
* @map: Bitmap describing which ports are forwarded
* @delta: Offset between the original destination and mapped port number
*/
struct port_fwd {
enum port_fwd_mode mode;
uint8_t map[PORT_BITMAP_SIZE];
in_port_t delta[NUM_PORTS];
};
#endif /* PORT_FWD_H */